The Zoom Center command lets you enter drawing coordinates that will be centered in the drawing pane.

To use the Zoom Center command:

1. Select View > Zoom Center. The Zoom Center dialog box appears.
2. Enter the X and Y coordinates.
3. Select the zoom factor from the Zoom drop-down, then click OK.

Zoom Center Dialog Box

X: Defines the X coordinate of the point at which the model will be centered.

Y: Defines the Y coordinate of the point at which the model will be centered.

Zoom Factor: Defines the zoom level that will be applied when the zoom center command is initiated. Available zoom levels are listed in percentages of 25, 50, 75, 100, 125, 150, 200 and 400